Hvordan lage en baseballcap Med Transfer Paper av Elaine Estelle

1, Set out the board and iron.Turn on the iron thus it will heat up.

2, Acquire or manufacture enough transfer material to hide the complete

hat. 2 totally written 8-by-10 sheets ought to be enough.

3, Measure every section of the hat with a tapeline. The hat could be a

series of triangles stitched along during a dome form, additionally to the

bill.

4, Mark the scale of every section on the reverse aspect of the

transfer paper. Connect the points of every triangle to make the

complete perimeter of every section.

5, Repeat the method for the brim of the cap, that could be a broad,

slightly arched form. live round the outer reaches of the brim, first.

6, Hold the tapeline perpendicular to the bill, flat against the cap, to live

the fourth aspect of the bill. it'll be tough to induce Associate in Nursing

correct measuring if you hold the tapeline down flat on prime of the bill

as a result of the tapeline is straight, however the road you're measure is

are cuate.

7, Cut every section out of the paper.

8, Lay the hat as flats as doable to facilitate ironing. you'll work one

section at a time, thus you merely need to worry regarding keeping one

section wholly flat at any given time. acting at the sting of the board might

create that easier.

9, Line-up a chunk of transfer material with its corresponding section on

the hat. Hold the new iron to the rear aspect of the transfer to start the

transferring method.

10, Follow the manufacturer's directions to see however long to iron every

section.

11, Remove the iron from the hat. permit