Hvordan lage en baseballcap Med Transfer Paper Happy Great

1, Set out the board and iron.Turn on the iron thus it will heat up.

2, Acquire or manufacture enough transfer material to hide the complete hat. 2 totally written 8-by-10 sheets ought to be enough.

3, Measure every section of the hat with a tapeline. The hat could be a of triangles stitched along during a dome form, additionally to the bill.

4, Mark the scale of every section on the reverse aspect of the transfer paper. Connect the points of every triangle to make the complete perimeter of every section.

5, Repeat the method for the brim of the cap, that could be a broad, slightly arched form. live round the outer reaches of the brim, first.

6, Hold the tapeline perpendicular to the bill, flat against the cap, to live the fourth aspect of the bill. it'll be tough to induce Associate in Nursing correct measuring if you hold the tapeline down flat on prime of the bill as a result of the tapeline is straight, however the road you're measure is are Cuate.

7, Cut alle seksjonen ut for papir.

8, Lay the hat as flats as doable to facilitate ironing. you'll work one section at a time, thus you merely need to worry regarding keeping one section wholly flat at any given time. acting at the sting of the board might create that easier.

9, Line-up a chunk of transfer material with its corresponding section on the hat. Hold the new iron to the rear aspect of the transfer to start the transferring method.

10, Follow the manufacturer's directions to see however long to iron every section.

11, Remove the iron from the hat. permit the transfer a flash to chill. Peel back the paper.

12, Repeat this method on every section, till you have got